Pelican 1173,O-RING,1170,LID

On construction sites and in mobile workshops, equipment cases travel in open utes and dusty corridors where fine grit and sudden rain penetrate poorly sealed lids. The Pelican 1173 O-ring is the factory replacement seal for the 1170 protector case, restoring the watertight and dustproof barrier that keeps sensitive instruments, electronics and spare parts operational after every move.

Fitting the ring takes seconds: remove the worn seal from the lid groove, clean the channel, and press the new O-ring into place until it seats evenly around the full perimeter. The moulded profile matches the original groove geometry so the lid clamps down with the same compression force, re-establishing the IP-rated seal without tools or adhesives. Maintenance crews carry a spare in each service kit because a compromised seal risks thousands of dollars in damaged calibration gear or ruined components during a single wet shift.

This genuine Pelican part is made for the 1170 case series and suits any operation that relies on plastic crates for rugged transport protection. Order the 1173 when your current seal shows flattening, cracking or permanent set.

Features

• Genuine Pelican replacement O-ring for 1170 protector case lids
• Restores original watertight and dustproof seal performance
• Tool-free installation into existing lid groove
• Moulded profile matches factory compression specifications
• Essential spare for field service kits and site maintenance stores