GRIPPS Tool Ring H01037 - 25mm (10 Pack)

Securing hand tools at height starts with a reliable connection point that will not slip or deform under load. These 25mm rings give every spanner, hammer or tape measure a dedicated anchor so a tool lanyard can be clipped on and stay put through a full shift on scaffolding, formwork or rooftop work. The pack of ten covers a standard kit for a small crew, reducing the chance that a missing ring leaves a tool untethered.

Each ring slides over the tool handle or through a pre-drilled hole and seats against the shaft, creating a low-profile loop that does not snag on guardrails or catch in a tool belt. The circular profile distributes pull force evenly, so the attachment point remains intact even when a dropped tool arrests suddenly. Riggers and scaffolders appreciate the quick visual check - if the ring is in place, the tool is tied off; no fiddly knots or tape wraps to inspect. This simplicity speeds up pre-start checks and keeps the focus on the task rather than on re-rigging connections.

The 25mm internal diameter suits common tool handle sizes across construction and maintenance trades. Supplied as a 10 pack, they integrate directly with existing drop prevention systems and height safety equipment programs. Keep a pack in the site store so every new tool gets a ring before it leaves the ground.

• 25mm internal diameter fits standard tool handles
• Pack of 10 covers a typical crew toolkit
• Low-profile loop reduces snag points on structure
• Even load distribution under sudden arrest
• Quick visual confirmation of tether status
• Compatible with common tool lanyard clips
• Supports site drop prevention compliance