Pelican 1556 Air Case with Foam - Black

Flight lines and remote airstrips demand gear that survives baggage handlers, rotor wash and sudden pressure changes without adding payload weight. The Pelican 1556 Air case fits that environment, offering a structural shell that meets airline carry-on limits while shielding sensitive avionics, camera bodies and lens kits from impact and ingress.

This pelican case uses next-generation HPX resin to cut mass by up to forty percent against legacy models, yet the honeycomb wall geometry retains crush resistance for stacked cargo holds. A double-throw latch system secures with one hand while wearing gloves, and the automatic purge valve equalises cabin altitude shifts without letting moisture inside. Interior configurability comes from Pick N Pluck foam layers or optional padded dividers, letting a camera operator or avionics tech reorganise compartments between missions. Stainless steel padlock hasps accept TSA locks for regulated airside transit, and the moulded handle balance point stays centred when fully loaded.

The watertight polymer o-ring seal and pressure-relief valve combine to keep internal humidity stable from sea level to cruise altitude. This hard case suits aerial survey crews, film units flying into bush strips and defence maintainers moving calibrated instruments across bases.

• HPX resin shell reduces weight versus standard polymer cases
• Automatic purge valve equalises pressure during altitude changes
• Watertight o-ring seal blocks moisture and dust ingress
• Double-throw latches operate single-handed with gloves on
• Pick N Pluck foam or padded divider options for custom fit
• Stainless steel padlock hasps accept TSA-approved locks
• Meets most airline carry-on dimensional allowances