Pelican 1615OR,O-RING,LID

A worn lid seal lets dust and moisture into a Pelican 1615 case, putting sensitive gear at risk during transport or long-term storage. This genuine O-ring replaces the original factory seal so the case performs to its original specification again. It is the single component that keeps the enclosure airtight and watertight when the latches are clamped down.

Fitting the ring takes only a minute: pull the old cord from the lid groove, press the new O-ring into the channel evenly around the perimeter, and close the latches to seat it. The elastomer material compresses uniformly under latch pressure, closing the gap that develops after years of cycling. Maintenance crews, field technicians, and logistics teams rely on this refresh to keep calibration instruments, electronics, and spares protected inside plastic crates that move between vehicles, warehouses, and job sites.

The part is moulded to the exact cross-section and diameter required for the 1615 lid groove. No tools are needed for installation, and the seal is ready for service immediately. Keep a spare in the workshop so the next scheduled inspection can swap seals on the spot and return the case to frontline duty without delay.

Features

• Genuine Pelican replacement O-ring for model 1615 case lids
• Restores original watertight and dustproof seal performance
• Press-fit installation into existing lid groove requires no tools
• Elastomer construction resists compression set over repeated cycles
• Suits cases protecting electronics, instruments, and spare parts
• Extends service life of protective cases in heavy-use environments