Glove Clip Keeper

Keeping hand protection ready at the hip solves a daily frustration on construction sites and in workshops. When a tradie steps away from a task to check plans, operate a radio, or climb a ladder, gloves often end up on dusty surfaces or lost in a pocket. This clip anchors them to a belt loop, harness, or hard hat brim so they stay clean and within reach for the next lift or cut.

The spring-loaded jaws grip cuff material without tearing nitrile gloves or leather palms, and the low-profile body does not snag on scaffolding or pipe runs. A supervisor can clip a pair on each side of a harness for hot-swap changes during a shift, while an apprentice avoids the cost and downtime of replacing lost pairs every week. It also reduces the temptation to work bare-handed because the gear is right there, supporting compliance across the crew.

Lightweight polymer construction resists UV and chemical splash, and the stainless-steel spring holds tension through repeated cycles. Pair it with safety glasses and ear muffs on the same belt for a complete access point. The result is faster task transitions and fewer missing-glove incidents on site.

Features

• Spring-loaded jaws grip cuffs without tearing
• Attaches to belt loops, harnesses or hard hat brims
• Low-profile shape avoids snag hazards
• UV and chemical-splash resistant polymer body
• Stainless-steel spring maintains tension over time
• Keeps hand protection clean and immediately accessible