GRIPPS Gripp Shrink H03005 - 50mm x 50mm (10 Pack)

Loose or improvised tether points are a common failure point in drop prevention systems, especially when standard clips cannot grip irregular tool handles. The GRIPPS Gripp Shrink range solves this by providing a heat-activated sleeve that conforms tightly around the tool shaft, creating a permanent, low-profile attachment point that will not slide off during use. This 50 mm length suits a wide variety of hand tools carried on scaffolding, rooftops, or elevated work platforms.

Each sleeve is applied by sliding it over the tool handle and applying heat until it shrinks and bonds to the surface. The result is a clean connection point that accepts a tool lanyard carabiner without adding bulk or snagging on adjacent gear. Because the bond is formed by the material itself rather than a mechanical clamp, there are no screws to loosen, no stitching to abrade, and no moving parts to fail under vibration. A ten-pack lets a crew outfit an entire toolkit in one session, reducing the downtime of fitting connectors one by one across a shift.

The 50 mm size covers most standard hammer, wrench, and driver handles found on commercial sites. Supplied as a ten-pack for crew-level deployment. Ideal for height safety officers and scaffolders building compliant drop prevention kits.

• Heat-shrink sleeve creates permanent tool tether point
• 50 mm length fits common hand tool handles
• Low-profile design reduces snag risk on structure
• No mechanical fasteners to loosen or fail
• Ten-pack suits crew toolkit rollout
• Compatible with standard tool lanyard carabiners
• Supports drop prevention compliance on elevated worksites