Pelican 1485OR,O-RING,LID

Storepersons and logistics coordinators rely on this Pelican 1485 lid O-ring to keep protective cases sealing properly. The rubber gasket sits in the lid channel and maintains the barrier that stops dust, splashes and humidity from reaching sensitive contents during daily warehouse movements or inter-site transport. When the original seal wears or takes a permanent set, the case loses its protective rating and the gear inside is exposed.

Fitting the replacement takes only a minute: peel the old ring from its groove, clean the channel, and press the new O-ring into place evenly around the full perimeter. No tools or adhesives are required. The fresh seal restores the tight closure that prevents ingress when cases are stacked on pallets, loaded onto trucks or stored on warehouse shelving alongside plastic crates and storage bins. Maintenance teams typically keep a few spares in the crib so a damaged seal can be swapped during a pre-shift check without delaying the job.

The 1485-321-000 part number identifies the correct profile for the 1485 case lid. Keeping a supply on hand means cases stay serviceable longer, protecting instruments, electronics and spares across transport and storage cycles.

Features

• Direct replacement lid seal for Pelican 1485 protective cases
• Restores dust and moisture barrier after original gasket wears
• Tool-free installation into existing lid groove
• Suits cases used in warehousing, transport and workshop environments
• Extends service life of protective equipment cases