Pelican Standard Handle Pin

A broken handle stops a pelican case from being moved safely across a workshop floor or loaded into a service vehicle. This standard pin-handle is the direct replacement part, letting maintenance crews swap out a cracked or bent grip in minutes without tools. Keeping a few on the shelf means a damaged case goes back into rotation the same shift instead of sitting in a corner waiting for a warranty claim.

Installation is a simple push-pin action: line up the holes, press the pins home, and the handle locks into the moulded recesses. The low-profile design sits flush when folded, so cases still stack cleanly on pallets or in ute trays. Because the pins are captive, there are no loose screws to drop in grass or lose down a drain, and the ergonomic grip gives a solid hold even with greasy gloves. Supervisors appreciate that the repair is visible at a glance during pre-start checks, reducing the chance a tech grabs a case that could fail mid-lift.

The part is moulded from the same high-impact polymer as the original hardware and matches the factory pin spacing exactly. It suits the full range of standard Pelican protective case models used across mining, defence and broadcast crews. A cost-effective way to keep the fleet moving in dust, heat and daily rough handling.

Features

• Direct replacement pin-handle for standard Pelican cases
• Tool-free push-pin installation in seconds
• Low-profile fold-flat design allows clean stacking
• Captive pins eliminate lost hardware on site
• Ergonomic grip shaped for gloved hands
• Matches original factory pin spacing and polymer